Cessna Piper Super Cub Airplane Aviation Weathervane * DIY KIT * NOT FINISHED

Description

Our 21" wingspan Cessna weathervane is machined from  9/16" solid cedar  wood and  is about 15" in length . The 3 5/8" propeller is mahogany with cypress blades and mounts with a brass screw and a bushing .
The plane mounts via a 2"  deep tube pocket  on a 1/4"  metal pin ( included ) . Our metal to metal contact allows a free turning craft that will turn with wind direction.
Mount on a fencepost , 2x2 stake , railing , found item , tree limb .... Anywhere or on anything you can drill a perpendicular hole and drive in the pin.
****************************************
This is a pre fitted  and unassembled plane that ships  in pieces and will require you to sand , paint and re assemble yourself.  Written Instructions are NOT included . So ......
******************************************
Phillips & flat head screwdrivers needed
1) Place finished wing upsidedown on a table edge
2) Insert all 4 painted 1/8" steel wing supports into the wing holes.
3) Making sure the wing and fuselage are oriented correctly , lower the upsidedown fuselage between the steel rods and CAREFULLY guide the rods into the fuselage pockets as you push down until the wing is completely seated.
4) Turn the plane right side up , check for alignment and drive in the 2 screws (Phillips head)
5) Attach propeller (flat head)